Command Reference Guide

Interfaces | 607
show interfaces dampening
c e s
Display interface dampening information.
Syntax
show interfaces dampening [[interface] [summary] [detail]]
Parameters
Defaults
No default values or behavior.
Command Modes
EXEC
Command
History
Example
FTOS#show interfaces dampening
Interface Supp Flaps Penalty Half-Life Reuse Suppress
Max-Sup
State
Gi 3/2 Up 0 0 20 800 4500 120
Gi 3/10 Up 0 0 5 750 2500 20
FTOS#
Related
Commands
interface
(Optional) Enter one of the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by
the slot/port information.
summary
(OPTIONAL) Enter the keyword summary to display the current summary of
dampening data, including the number of interfaces configured and the number
of interfaces suppressed, if any.
detail
(OPTIONAL) Enter the keyword detail to display detailed interface dampening
data.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced
dampening Configure dampening on an interface
show interfaces Display information on a specific physical interface or virtual
interface.
show interfaces configured Display any interface with a non-default configuration.