Command Reference Guide

604 | Interfaces
www.dell.com | support.dell.com
0 Vlans
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 1w0d5h
FTOS#
Example
(10G SFP+
Interface -
C-Series)
FTOS#show interfaces tengigabitethernet 0/44
TenGigabitEthernet 0/44 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:32:44:26
Current address is 00:01:e8:32:44:26
Pluggable media present, SFP+ type is 10GBASE-CU5M
Medium is MultiRate
Interface index is 45417732
FTOS#
Example
(show interfaces
ManagementEthernet)
FTOS#show interfaces managementethernet 0/0
ManagementEthernet 0/0 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:8b:3d:e1
Current address is 00:01:e8:8b:3d:e1
Pluggable media not present
Interface index is 436486344
Internet address is 10.30.4.154/24
Link local IPv6 address: fe80::201:e8ff:fe8b:3de1/64
Global IPv6 address: 1010:10::1/64
Global IPv6 address: 2000:1::1/64
Virtual-IP is not set
Virtual-IP IPv6 address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:07:24
Queueing strategy: fifo
Input 55 packets, 4067 bytes, 54 multicast
Received 0 errors, 0 discarded
Output 40 packets, 6672 bytes, 39 multicast
Output 0 errors, 0 invalid protocol
Time since last interface status change: 00:07:19
Usage
Information
On the C-Series and S-Series, the interface counter “over 1023-byte pkts” does not increment
for packets in the range 9216 > x < 1023.
The Management port is enabled by default (no shutdown). If necessary, use the
ip address
command to assign an IP address to the Management port. If two RPMs are installed in your
system, use the
show redundancy command to display which RPM is the Primary RPM.
Related
Commands
show interfaces configured Display any interface with a non-default configuration.
show interfaces linecard Display information on all interfaces on a specific line card.
show interfaces phy