Command Reference Guide
60 | File Management
www.dell.com | support.dell.com
FTOS#$pgrade system ftp://username:password@10.11.1.1/FTOS-SB-7.7.1.0.bin
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Erasing Sseries ImageUpgrade Table of Contents, please wait
.!...........................................................................................
......................................................................................................
......................................................................................................
......................................................................................................
......................................................................................................
......................................................................................................
......................................................................................................
......................................................................................................
......................................................................................................
...........................!
12946259 bytes successfully copied
FTOS#reload
upgrade fpga-image
e
This command only be used on systems with SFM3 modules (and only when required by the
upgrade procedure in the release notes). Upgrade the FPGA version in the specified E-Series
SFM3 and automatically initiate an automatic reset to complete the version upgrade.
Syntax
upgrade fpga-image {sfm} {all | id} [booted | flash:// | ftp: |slot0: | tftp]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
Example
FTOS#upgrade sfm 1 autoreset
SFM1: upgrade in progress
!!! !!! !!!
SFM1: upgrade complete
SFM1 is active. Resetting it might temporarily impact traffic.
Proceed with reset [confirm yes/no]: yes
FTOS#
Related
Commands
0Usage
Information
On E-Series ExaScale, you cannot upgrade SFMs using this command when Cache Boot is
configured. If you attempt an upgrade, you must reload the chassis to recover.
sfm
Enter the keyword sfm to upgrade the FPGA on the SFMs.
rpm
Enter the keyword rpm to upgrade all processors on the RPM.
all
Enter the keyword all to upgrade the FPGA on all the SFMs.
id
Enter the keyword id to upgrade the FPGA on all a specific SFM.
Enter the path to the upgrade source. Entering <CR> updates the FPGA from the
flash.
Version 8.3.1.0 Added rpm option
Version 7.5.1.0 Introduced on E-Series
show sfm Display the SFM status.
upgrade (E-Series version) Upgrade the E-Series.










