Command Reference Guide

Interfaces | 583
Parameters
Defaults
This command has no default behavior or values.
Command Modes
CONFIGURATION
Command
History
Usage
Information
When creating an interface range, interfaces appear in the order they are entered; they are not
sorted. The command verifies that interfaces are present (physical) or configured (logical).
Important things to remember:
• Bulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a warning
message.
• The interface range prompt includes interface types with slot/port information for
valid interfaces. The prompt allows for a maximum of 32 characters. If the bulk
configuration exceeds 32 characters, it is represented by an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port range
is excluded from the prompt.
interface,
interface,...
Enter the keyword interface range and one of the interfaces — slot/port,
port-channel or VLAN number. Select the range of interfaces for bulk
configuration. You can enter up to six comma separated ranges—spaces are
not required between the commas. Comma-separated ranges can include
VLANs, port-channels and physical interfaces.
Slot/Port information must contain a space before and after the dash. For
example,
interface range gigabitethernet 0/1 - 5 is valid; interface range
gigabitethernet 0/1-5
is not valid.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by
a number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed
by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to
4094.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported
2094.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version
6.1.1.0
Introduced for E-Series