Command Reference Guide

File Management |57
Defaults
No configuration or default values
Command Modes
EXEC Privilege
Command
History
Usage
Information
A system message appears stating the Bootflash upgrade status. Reload the system to boot
from the upgraded boot images.
Once the URL is specified, the same downloaded image can be used for upgrading an
individual RPM, line cards, SFM FPGA, and system-image for cache-boot without specifying
the
file-url again using the command upgrade {bootflash-image | bootselector-image |
system-image} {all | linecard linecard-slot | rpm}. After 20 minutes, the cached memory is
released and returned for general use, but the URL is maintained and you do not have to
specify it for subsequent upgrades.
Related
Commands
upgrade (C-Series version)
c
Upgrade the bootflash or boot selector image on a processor.
Syntax
upgrade {bootflash-image | bootselector-image | system-image}
{
all | linecard {number | all} | rpm} [booted | file-url | repair]
Parameters
booted
Enter this keyword to upgrade using the image packed with the
currently running FTOS image.
file-url
Enter the following location keywords and information to upgrade
using an FTOS image other than the one currently running:
Enter the transfer method and file location:
flash://filename
ftp://userid
:password@hostip/filepath
slot0://filename
tftp://hostip
/filepath
Version 7.7.1.0 Removed alt-bootflash-image, alt-bootselector-image, alt-system-image
options
, rp1, rp2, and cp options.
E-Series original Command
upgrade fpga-image Upgrade the FPGA version in the specified E-Series SFM.
boot system Display configured boot image information
bootflash-image Enter the keyword bootflash-image to upgrade the bootflash
image.
bootselector-image Enter the keyword bootselector-image to upgrade the boot
selector image. Use with TAC supervision only.
system-image Enter the keyword system-image to upgrade the system image.
Use with TAC supervision only.