Command Reference Guide

566 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
Usage
Information
This command enables the IGMP switch to send General Queries periodically. This is useful
when there is no multicast router present in the VLAN because the multicast traffic does not
need to be routed. An IP address must be assigned to the VLAN interface for the switch to act
as a querier for this VLAN.
show ip igmp snooping mrouter
c e s
Display multicast router interfaces.
Syntax
show ip igmp snooping mrouter
[vlan number]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS(conf-if-po-100)#show ip ig snooping mrouter
Interface Router Ports
Vlan 100 Po 100
Usage
Information
If the port channel is a VLT port channel, an asterisk (*) after the port channel number (Po
100*) indicates the port channel is locally down and that a remote VLT port is up.
Related
Commands
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command
vlan number
Enter the keyword vlan followed by the vlan number.
Range: 1 to 4094
Version 8.3.7.0, Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command
ip igmp snooping
mrouter
Use this command to configure a static connection to the multicast
router.
show ip igmp groups Use this IGMP command to view groups