Command Reference Guide

550 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
• ip igmp access-group
• ip igmp group-join-limit
• ip igmp immediate-leave
• ip igmp last-member-query-interval
• ip igmp querier-timeout
• ip igmp query-interval
• ip igmp query-max-resp-time
• ip igmp ssm-map
• ip igmp static-group
• ip igmp version
• show ip igmp groups
• show ip igmp interface
• show ip igmp ssm-map
clear ip igmp groups
c e s
Clear entries from the group cache table.
Syntax
clear ip igmp groups
[group-address | interface]
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
IGMP commands accept only non-VLAN interfaces — specifying VLAN will not yield a
result.
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For an 100/1000 Base-T Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet
followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed
by the slot/port information.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command