Command Reference Guide

530 | GARP VLAN Registration (GVRP)
www.dell.com | support.dell.com
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults
Disabled
Command Modes
CONFIGURATION-INTERFACE
Command
History
Related
Commands
gvrp registration
c e s
Configure the GVRP register type.
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the
gvrp register normal command.
Parameters
Defaults
Default registration is normal
Command Modes
CONFIGURATION-INTERFACE
Command
History
Usage
Information
The fixed registration prevents an interface, configured via the command line to belong to a
VLAN (static configuration), from being un-configured when it receives a Leave message.
Therefore, the registration mode on that interface is fixed.
The
normal registration is the default registration. The port’s membership in the VLANs
depends on GVRP. The interface becomes a member of VLANs after learning about the
VLAN through GVRP. If the VLAN is removed from the port that sends GVRP
advertisements to this device, then the port will stop being a member of the VLAN.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on C, E, and S-Series
disable Globally disable GVRP.
fixed
Enter the keyword fixed followed by the VLAN range in a comma
separated VLAN ID set.
normal
Enter the keyword normal followed by the VLAN range in a comma
separated VLAN ID set.
This is the default
forbidden
Enter the keyword forbidden followed by the VLAN range in a
comma separated VLAN ID set.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on C, E, and S-Series