Command Reference Guide

Data Center Bridging | 465
set-pgid
Configure the priority-group identifier.
Syntax
set-pgid value
To remove the priority group, use the no set-pgid command.
Parameters
Defaults
none
Command Modes
PRIORITY-GROUP
Command
History
Related
Commands
show dcb
Displays the data center bridging status, the number of PFC-enabled ports, and the number of
PFC-enabled queues.
Syntax
show dcb [stack-unit unit-number] [port-set port-set port-set number]
Parameters
Command Mode
EXEC PRIVILEGE
Command
History
Example
FTOS# show dcb
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2 (current), 2 (configured)
Usage
Information
Specify a stack-unit number on the Master switch in a stack.
value
Enter the priority group identification.
Range: 0 to 7.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
priority-group qos-policy Create an ETS priority group.
priority-list Configure the 802.1p priorities.
unit number
Enter the DCB unit number.
Range: 0 to 5.
port-set number
Enter the port-set number
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module