Command Reference Guide

Bare Metal Provisioning | 415
show reload-type
Display the currently configured reload mode.
Syntax
show reload-type
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
Use the show reload-type command to check the currently configured auto-configuration
mode (Jumpstart or Normal reload) on a switch running BMP 2.0.
You can also use the
show bootvar command to display the current reload mode for BMP 2.0
with the path of the FTOS image file retrieved from a DHCP server.
Example
FTOS#show reload-type
Reload-Type : normal-reload [Next boot : normal-reload]
Related
Commands
stop jump-start
Stop the switch from reloading in Jumpstart mode to prevent an infinite loop.
Syntax
stop jump-start
Defaults
None
Command Modes
EXEC Privilege
Command
History
Related
Commands
Usage
Information
Use the stop jump-start command on a switch running BMP 2.0 if the switch enters a loop
while reloading in Jumpstart mode; loop occurs when the switch is continuously trying to
contact a DHCP server and a DHCP server is not found. The
stop jump-start command stops
the switch from connecting to the DHCP server. After the
stop jump-start command is used,
the next default reload type will be a normal reload. This will be indicated in the show
reload-type command.
Version 8.3.10.1 Introduced on S4810.
reload-type Configure the reload mode as normal or Jumpstart.
Version 8.3.10.1 Introduced on S4810.
reload-type Configure the reload mode as normal or Jumpstart.