Command Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 365
Command Modes
EXEC
EXEC Privilege
Command
History
Example
(S4810)
FTOS#show ip bgp neighbors
BGP neighbor is 10.10.10.1, remote AS 23456, external link
BGP version 4, remote router ID 10.10.10.1
BGP state ESTABLISHED, in this state for 00:00:35
. . .
Capabilities received from neighbor for IPv4 Unicast :
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
4_OCTECT_AS(65)
ADD_PATH (69)
CISCO_ROUTE_REFRESH(128)
Example
(partial)
FTOS#show ip bgp neighbors
BGP neighbor is 100.10.10.2, remote AS 200, external link
BGP version 4, remote router ID 192.168.2.101
BGP state ESTABLISHED, in this state for 00:16:12
Last read 00:00:12, last write 00:00:03
Hold time is 180, keepalive interval is 60 seconds
Received 1404 messages, 0 in queue
3 opens, 1 notifications, 1394 updates
6 keepalives, 0 route refresh requests
Sent 48 messages, 0 in queue
3 opens, 2 notifications, 0 updates
43 keepalives, 0 route refresh requests
Minimum time between advertisement runs is 30 seconds
Minimum time before advertisements start is 0 seconds
routes
(OPTIONAL) Enter the keywords routes to view only the neighbor’s
feasible routes.
received-routes
[network
[
network-mask]
(OPTIONAL) Enter the keywords received-routes followed by either
the network address (in dotted decimal format) or the network mask (in
slash prefix format) to view all information received from neighbors.
Note: neighbor soft-reconfiguration inbound must be configured prior to
viewing all the information received from the neighbors.
denied-routes
[network
[
network-mask]
(OPTIONAL) Enter the keywords denied-routes followed by either the
network address (in dotted decimal format) or the network mask (in slash
prefix format) to view all information on routes denied via neighbor
inbound filters.
Version 8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows
ADDPATH parameters.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.5.1.0 Added detail option and output now displays default MED value
Version 7.2.1.0 Added received and denied route options
Version 6.3.10 The output is changed to display the total number of advertised prefixes