Command Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 353
Usage
Information
When you enable bgp non-deterministic-med command, the show ip bgp command output for a
BGP route does not list the INACTIVE reason.
Example
FTOS>show ip bgp
BGP table version is 847562, local router ID is 63.114.8.131
Status codes: s suppressed, d damped, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 0.0.0.0/0 63.114.8.33 0 18508 i
* 3.0.0.0/8 63.114.8.33 0 18508 209 701 80 i
*> 63.114.8.33 0 18508 701 80 i
*> 3.3.0.0/16 0.0.0.0 22 32768 ?
63.114.8.35 0 18508 ?
*> 4.0.0.0/8 63.114.8.33 0 18508 701 1 i
*> 4.2.49.12/30 63.114.8.33 0 18508 209 i
* 4.17.250.0/24 63.114.8.33 0 18508 209 1239 13716 i
*> 63.114.8.33 0 18508 701 1239 13716 i
* 4.21.132.0/23 63.114.8.33 0 18508 209 6461 16422 i
*> 63.114.8.33 0 18508 701 6461 16422 i
*> 4.24.118.16/30 63.114.8.33 0 18508 209 i
*> 4.24.145.0/30 63.114.8.33 0 18508 209 i
*> 4.24.187.12/30 63.114.8.33 0 18508 209 i
*> 4.24.202.0/30 63.114.8.33 0 18508 209 i
*> 4.25.88.0/30 63.114.8.33 0 18508 209 3561 3908 i
*> 5.0.0.0/9 63.114.8.33 0 0 18508 ?
*> 5.0.0.0/10 63.114.8.33 0 0 18508 ?
*> 5.0.0.0/11 63.114.8.33 0 0 18508 ?
--More--
Table 9-1 defines the information displayed in the previous example
Related
Commands
Command
History
Table 9-1. show ip bgp Command Example Fields
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router.
If 0.0.0.0 is listed in this column, then local routes exist in the
routing table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight
Path Lists all the ASs the route passed through to reach the destination
network.
show ip bgp community View BGP communities.
neighbor maximum-prefix Control number of network prefixes received.
Version 8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows
ADDPATH parameters.
Version 8.3.7.0 Introduced on the S4810.