Command Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 347
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
Though FTOS does not generate a route due to backdoor config, there is an option for
injecting/sourcing a local route in presence of network backdoor config on a learned route.
Command
History
redistribute
c e s
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the
no redistribution {connected | static} command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
ip-address
Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for example, /
24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
connected
Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all routes).