Command Reference Guide

332 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Defaults
as above
Command Modes
ROUTER BGP
Usage
Information
This feature is advertised to BGP neighbors through a capability advertisement. In receiver
only mode, BGP saves the advertised routes of peers that support this capability when they
restart.
Command
History
neighbor local-as
c e s
Configure Internal BGP (IBGP) routers to accept external routes from neighbors with a local
AS number in the AS number path
Syntax
neighbor {ip-address | peer-group-name} local-as as-number [no-prepend]
To return to the default value, use the
no neighbor {ip-address | peer-group-name} local-as
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
restart-time seconds Enter the keyword restart-time followed by the maximum
number of seconds needed to restart and bring-up all the peers.
Range: 1 to 3600 seconds
Default: 120 seconds
stale-path-time seconds
Enter the keyword stale-path-time followed by the maximum
number of seconds to wait before restarting a peer’s stale paths.
Default: 360 seconds.
role receiver-only
Enter the keyword role receiver-only to designate the local
router to support graceful restart as a receiver only.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to set the advertisement interval for all
routers in the peer group.
as-number Enter the AS number to reset all neighbors belonging to that AS.
Range: 0-65535 (2-Byte) or
1-4294967295 (4-Byte) or
0.1-65535.65535 (Dotted format)
no prepend Specifies that local AS values are not prepended to announcements from
the neighbor.