Command Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 321
debug ip bgp soft-reconfiguration
c e s
Enable soft-reconfiguration debug.
Syntax
debug ip bgp {ip-address | peer-group-name} soft-reconfiguration
To disable, use the no debug ip bgp {ip-address | peer-group-name} soft-reconfiguration
command.
Parameters
Defaults
Disabled
Command Modes
EXEC Privilege
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging. If no neighbor is
specified, debug is turned on for all neighbors.
Command
History
debug ip bgp updates
c e s
Enables you to view information about BGP updates.
Syntax
debug ip bgp updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the
no debug ip bgp [ip-address | peer-group peer-group-name]
updates [in | out] command.
Parameters
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name
(OPTIONAL) Enter the name of the peer group to disable or enable all
routers within the peer group.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.2.1.0 Introduced
in (OPTIONAL) Enter the keyword in to view only BGP updates received
from neighbors.
out
(OPTIONAL) Enter the keyword out to view only BGP updates sent to
neighbors.
prefix-list
prefix-list-name
(OPTIONAL) Enter the keyword prefix-list followed by the name of an
established prefix list. If the prefix list is not configured, the default is
permit (to allow all routes).