Command Reference Guide

294 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
The following commands enable you to configure and enable BGP.
• address-family
• aggregate-address
• bgp add-path
• bgp always-compare-med
• bgp asnotation
• bgp bestpath as-path ignore
• bgp bestpath as-path multipath-relax
• bgp bestpath med confed
• bgp bestpath med missing-as-best
• bgp bestpath router-id ignore
• bgp client-to-client reflection
• bgp cluster-id
• bgp confederation identifier
• bgp confederation peers
• bgp dampening
• bgp default local-preference
• bgp enforce-first-as
• bgp fast-external-fallover
• bgp four-octet-as-support
• bgp graceful-restart
• bgp log-neighbor-changes
• bgp non-deterministic-med
• bgp recursive-bgp-next-hop
• bgp regex-eval-optz-disable
• bgp router-id
• bgp soft-reconfig-backup
• capture bgp-pdu neighbor
• capture bgp-pdu max-buffer-size
• clear ip bgp
• clear ip bgp dampening
Note: FTOS Version 7.7.1 supports 2-Byte (16-bit) and 4-Byte (32-bit) format for Autonomous System
Numbers (ASNs), where the 2-Byte format is 1-65535, the 4-Byte format is 1-4294967295.
Note: FTOS Version 8.3.1.0 supports Dotted format as well as the Traditional Plain format for AS
Numbers. The dot format is displayed when using the show ip bgp commands. To determine the
comparable dot format for an ASN from a traditional format, use ASN/65536. ASN%65536.
For more information about using the 2 or 4-Byte format, refer to the FTOS Configuration Guide.