Command Reference Guide

CLI Basics | 27
2. Enter the router rip command.The prompt changes to include (conf-router_rip).
You can switch to the INTERFACE mode by using the interface command or you can switch
to the ROUTER OSPF mode by using the
router ospf command.
ROUTER ISIS Mode
Use the ROUTER ISIS mode to configure ISIS on the E-Series, as described in the E-Series
E-Series
FTOS Command Line Reference Guide chapter Intermediate System to Intermediate
System (IS-IS).
To enter ROUTER ISIS mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the router isis [tag] command.The prompt changes to include (conf-router_isis).
You can switch to the INTERFACE mode by using the interface command or you can switch
to the ROUTER RIP mode by using the
router rip command.
ROUTER BGP Mode
Use the ROUTER BGP mode to configure BGP on the C-Series or E-Series, as described in
Chapter 9, Border Gateway Protocol IPv4 (BGPv4).
To enter ROUTER BGP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the router bgp as-number command.The prompt changes to include
(conf-router_bgp).
You can return to the CONFIGURATION mode by entering the exit command.
VLT DOMAIN Mode
Use VLT DOMAIN mode to enable and configure the VLT domain protocol, as described in
Chapter 57, Virtual Link Trunking (VLT).
To enter VLT DOMAIN mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the config-vlt-domain command.
You can return to the CONFIGURATION mode by entering the exit command.