Command Reference Guide

232 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Command Modes
INTERFACE
Command
History
Usage
Information
You can assign one ACL (standard or extended) to an interface.
Prior to 7.8.1.0, names are up to 16 characters long.
Related
Commands
show mac access-lists
c e s
Display all of the Layer 2 ACLs configured in the system, whether or not they are applied to
an interface, and the count of matches/mismatches against each ACL entry displayed.
Syntax
show mac access-lists [access-list-name] [interface interface] [in | out]
Parameters
Command Modes
EXEC Privilege
Command
History
\
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
mac access-list standard Configure a standard MAC ACL.
mac access-list extended Configure an extended MAC ACL.
access-list-name
Enter the name of a configured MAC ACL, up to 140 characters.
interface interface Enter the keyword interface followed by the one of the following
keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel
followed by a number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
followed by the slot/port information.
in | out
Identify whether ACL is applied on ingress or egress side.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.4.1.0 Introduced