Command Reference Guide

158 | 802.1ag
www.dell.com | support.dell.com
Command
History
mep cross-check start-delay
s
Configure the amount of time the system waits for a remote MEP to come up before the
cross-check operation is started.
Syntax
mep cross-check start-delay
number
Parameters
Defaults
3 ccms
Command Modes
ETHERNET CFM
Command
History
ping ethernet
s
Send a Loopback message.
Syntax
ping ethernet domain
[name l level] ma-name m a-name remote {dest-mep-id | mac-addr
mac-address} source {src-mep-id | port interface}
Parameters
Defaults
None
Command Modes
EXEC Privilege
Command
History
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on S-Series
start-delay number
Enter a start-delay in seconds.
Range: 3-100 seconds
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on S-Series
name | level Enter the domain name or level.
ma-name ma-name
Enter the keyword followed by the maintenance association
name.
dest-mep-id
Enter the MEP ID that will be the target of the ping.
mac-addr mac-address Enter the keyword followed by the MAC address that will be
the target of the ping.
src-mep-id Enter the MEP ID that will originate the ping.
port interface Enter the keyword followed by the interface that will
originate the ping.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on S-Series