Command Reference Guide

1502 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Command
History
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
e c s
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the FTOS returns
“No Active VRRP group.”
Syntax
show vrrp ipv6 [vrid] [interface] [brief]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series.
Version 8.3.10.0 Introduced on S4180
Version 8.3.2.0 Introduced on E-Series TeraScale
vrid (OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to view
only that group.
Range: 1 to 255.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed by a
number:
E-Series Range: 1 to 255 for TeraScale
• For SONET interfaces, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by the VLAN ID.
The VLAN ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the
VRRP groups on the E-Series.
Version 8.3.10.0 Introduced on S4810
Version 8.3.2.0 Introduced