Command Reference Guide

1500 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Syntax
vrrp-group vrrp-id
Parameters
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP address is
configured. When you delete the virtual address, the VRRP group stops sending VRRP
packets.
Related
Commands
IPv6 VRRP Commands
The IPv6 VRRP commands are:
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
• advertise-interval
• description
• disable
• hold-time
• preempt
• priority
• show config
• track
• virtual-address
vrrp-id
Enter a number as the group ID.
Range: 1 to 255.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
virtual-address Assign up to 12 virtual IP addresses per VRRP group.