Command Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 1493
Usage
Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual
address with same IP address as the interface’s primary IP address and change the priority of
the VRRP group to 255.
If you set the priority to 255 and the virtual-address is not equal to the interface’s primary IP
address, an error message appears.
show config
c e s
View the non-default VRRP configuration.
Syntax
show config [verbose]
Parameters
Command Modes
VRRP
Command
History
Example
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
c e s
View the VRRP groups that are active. If no VRRP groups are active, the FTOS returns “No
Active VRRP group
.”
Syntax
show vrrp [vrrp-id] [interface] [brief]
verbose
(OPTIONAL) Enter the keyword verbose to view all VRRP group configuration
information, including defaults.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series