Command Reference Guide

1486 | Virtual Link Trunking (VLT)
www.dell.com | support.dell.com
Parameters
Command Modes
CONFIGURATION
Command
History
Related
Commands
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT
connection to an attached device.
Syntax
vlt-peer-lag port-channel id-number
Parameters
Defaults
Not configured.
Command Modes
INTERFACE PORT-CHANNEL
Command
History
domain-id
Enter the Domain ID number. You must configure the same domain ID on the
peer switch. VLT uses the domain ID to automatically create a VLT MAC
address for the domain.
Range of domain IDs: 1 to 1000.
peer-link
port-channel
Configure the VLT peer link.
Version 8.3.8.0 Introduced on S4810
show vlt
Use the show vlt brief command to display the delay-restore value.
id-number
Enter the port-channel number that will connect to another port channel in the
VLT peer.
Version 8.3.8.0 Introduced on S4810