Command Reference Guide

1472 | Uplink Failure Detection (UFD)
www.dell.com | support.dell.com
Downstream Interfaces : Te 13/2(Dis) Te 13/4(Dis) Te 13/11(Dis) Te 13/12(Dis) Te 13/13(Dis) Te 13/14(Dis) Te 13/15(Dis)
Uplink State Group : 6 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 7 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 16 Status: Disabled, Up
Upstream Interfaces : Gi 0/41(Dwn) Po 8(Dwn)
Downstream Interfaces : Gi 0/40(Dwn)
Related
Commands
uplink-state-group
s S50 only
Create an uplink-state group and enabling the tracking of upstream links on a switch/router.
Syntax
uplink-state-group group-id
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Usage
Information
After you enter the command, you enter uplink-state-group configuration mode to assign
upstream and downstream interfaces to the group.
An uplink-state group is considered to be operationally up if at least one upstream interface in
the group is in the link-up state.
An uplink-state group is considered to be operationally down if no upstream interfaces in the
group are in the link-up state. No uplink-state tracking is performed when a group is disabled
or in an operationally down state.
To delete an uplink-state group, enter the
no uplink-state-group group-id command.
To disable upstream-link tracking without deleting the uplink-state group, enter the
no enable
command in uplink-state-group configuration mode.
show running-config
uplink-state-group
Display the current configuration of one or more uplink-state groups.
uplink-state-group Create an uplink-state group and enabling the tracking of upstream
links.
group-id Enter the ID number of an uplink-state group. Range: 1-16.
Version 8.3.12.0 Introduced on S4810
Version 8.4.2.3 Introduced on the S-Series S50.