Command Reference Guide

S4810 u-Boot | 1463
reset
Reload the S4810 system.
Syntax
reset
Command Modes
uBoot
Command
History
Usage
Information
You must save your changes before resetting the system, or all changes will be lost.
save
Save configurations created in uBoot.
Syntax
save
Command Modes
uBoot
Command
History
Usage
Information
You must save your changes before resetting the system, or all changes will be lost.
setenv
Configure system settings.
Syntax
setenv [gatewayip address | primary_image f10boot location | secondary_image f10boot location |
default_image f10boot location | ipaddre address | ethaddr address |
enablepwdignore |
stconfigignore]
Parameters
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.7.0 Introduced on the S4810.
gatewayip address
Enter the IP address for the default gateway.
primary_image
Enter the keywords primary_image to configure the boot
parameters used in the first attempt to boot FTOS.
secondary_image
Enter the keywords secondary_image to configure boot
parameters used if the primary operating system boot selection is
not available.
default_image
Enter the keywords default_image to configure boot parameters
used if the secondary operating system boot parameter selection is
not available. The default location should always be the internal
flash device (flash:), and a verified image should be stored there.