Command Reference Guide

VLAN Stacking | 1457
On E-Series TeraScale, the two characters you enter in the CLI for number become the MSB,
as shown in Table 54-1.
On E-Series ExaScale, C-Series, and S-Series, four characters you enter in the CLI for
number
are interpreted as follows:
Related
Commands
vlan-stack trunk
c e s
Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network.
Syntax
vlan-stack trunk
To remove a trunk port designation from the selected interface, enter no vlan-stack trunk.
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
Table 54-1. Configuring a TPID on the E-Series TeraScale
number Resulting TPID
1 0x0100
10 0x1000
More than two characters. Configuration rejected.
Table 54-2. Configuring a TPID on the E-Series TeraScale
number Resulting TPID
1 0x0001
10 0x0010
81 0x0081
8100 0x8100
portmode hybrid Set a port (physical ports only) to accept both tagged and untagged frames. A
port configured this way is identified as a hybrid port in report displays.
vlan-stack trunk Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN
network.
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.8.1.0 Functionality augmented for C-Series and S-Series to enable multi-purpose use
of the port. Refer to Usage Information, below.