Command Reference Guide

1424 | Spanning Tree Protocol (STP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
FTOS(conf)#protocol spanning-tree 0
FTOS(config-stp)#
Usage
Information
STP is not enabled when you enter the SPANNING TREE mode. To enable STP globally on
the switch, enter no disable from the SPANNING TREE mode.
Related
Commands
show config
c e s
Display the current configuration for the mode. Only non-default values are displayed.
Syntax
show config
Command Modes
SPANNING TREE
Command
History
Example
FTOS(config-stp)#show config
protocol spanning-tree 0
no disable
FTOS(config-stp)#
show spanning-tree 0
c e s
Display the Spanning Tree group configuration and status of interfaces in the Spanning Tree
group.
Syntax
show spanning-tree 0 [active | brief | guard | interface interface | root | summary]
stp-id
Enter zero (0). FTOS supports one Spanning Tree group, group 0.
Version 8.3.7.0 Introduced on S4810
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
disable Disable Spanning Tree group 0. To enable Spanning Tree group 0, enter no disable.
Version 8.3.7.0 Introduced on S4810
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series