Command Reference Guide

Storm Control | 1415
Defaults
No default behavior or values
Command Modes
CONFIGURATION (conf)
Command
History
Usage
Information
Broadcast traffic (all 0xFs) should be counted against broadcast storm control meter, not
against the multicast storm control meter. It is possible, however, that some multicast control
traffic may get dropped when storm control thresholds are exceeded.
storm-control multicast (Interface)
c s
Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface
(ingress only) network only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
storm-control unknown-unicast (Configuration)
c e s
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
Syntax
storm-control unknown-unicast [percentage decimal_value [in | out]] | [wred-profile name]]
[
packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control
unknown-unicast
[percentage decimal_value [in | out] | [wred-profile name]]
[
packets_per_second in] command.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on C-Series and S-Series only
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of broadcast
traffic allowed into the network.
Range: 0 to 33554431
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on C-Series and S-Series