Command Reference Guide

S-Series Stacking Commands | 1405
Parameters
Defaults
When this value is not set, a switch joining the stack is given the next available sequential
stack member
identifier.
Command Modes
CONFIGURATION
Command
History
Related
Commands
stack-unit renumber
s
Change the stack member ID of any stack member or a stand-alone S-Series.
Syntax
stack-unit 0-11 renumber 0-11
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are
renumbered, only that specific unit will reset and come up with the new unit number.
Example
FTOS#stack-unit 5 renumber 6
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
0-11
Enter a stack member identifier, from 0 to 11, of the switch that you want to
add to the stack.
S25N|S25P|S25V||
S50N|S50V|S4810
Enter the S-Series model identifier of the switch to be added as a stack
member. This identifier is also referred to as the provision type.
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series
and S4810)
Display the current status of all stack members or a specific member.
0-11
The first instance of this value is the stack member unit identifier of the
switch that you want add to the stack.
Range: 0-11.
The second instance of this value is the desired new unit identifier number.
Version 7.7.1.0 Introduced on S-Series