Command Reference Guide

1404 | S-Series Stacking Commands
www.dell.com | support.dell.com
Related
Commands
stack-unit priority
s
Configure the ability of an S-Series switch to become the management unit of a stack.
Syntax
stack-unit 0-7 priority 1-14
Parameters
Defaults
0
Command Modes
CONFIGURATION
Command
History
Related
Commands
stack-unit provision
s
Pre-configure a logical stacking ID of a switch that will join the stack. This is an optional
command that is executed on the management unit.
Syntax
stack-unit 0-11 provision {S25N|S25P|S25V|S50N|S50V|S4810}
Admin
Status
The only currently listed status is Up.
Connection The stack port ID to which this unit’s stack port is connected
Table 50-1. show interfaces description Command Example Fields (continued)
Field Description
reset stack-unit Reset the designated S-Series stack member.
show hardware stack-unit Display the data plane or management plane input and output statistics
of the designated component of the designated stack member.
show system (S-Series
and S4810)
Display the current status of all stack members or a specific member.
upgrade (S-Series
management unit and
Z9000)
Upgrade the bootflash image or system image of the S-Series
management unit.
0-7
Enter the stack member unit identifier, from 0 to 7, of the switch on which you want to
set the management priority.
1-14
This preference parameter allows you to specify the management priority of one backup
switch over another, with 0 the lowest priority and 14 the highest.
The switch with the highest priority value will be chosen to become the management unit
if the active management unit fails or on the next reload.
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series
and S4810)
Display the current status of all stack members or a specific member.