Command Reference Guide

1402 | S-Series Stacking Commands
www.dell.com | support.dell.com
-- Stack-unit Status --
------------------------------------------------
Mgmt ID: 0
Stack-unit ID: 0
Stack-unit Redundancy Role: Primary
Stack-unit State: Active
Stack-unit SW Version: 7.7.1.0
Link to Peer: Up
-- PEER Stack-unit Status --
------------------------------------------------
Stack-unit State: Standby
Peer stack-unit ID: 1
Stack-unit SW Version: 7.7.1.0
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit: mgmt-id 0
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot Stack-unit: Enabled
Auto failover limit: 3 times in 60 minutes
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count: 0
Last failover timestamp: None
Last failover Reason: None
Last failover type: None
-- Last Data Block Sync Record: --
------------------------------------------------
Stack Unit Config: succeeded Jul 11 2012 09:42:35
Start-up Config: succeeded Jul 11 2012 09:42:35
Runtime Event Log: succeeded Jul 11 2012 09:42:35
Running Config: succeeded Jul 11 2012 09:42:35
ACL Mgr: succeeded Jul 11 2012 09:42:35
LACP: no block sync done
STP: no block sync done
SPAN: no block sync done
Related
Commands
show system stack-ports
s
Display information about the stacking ports on all switches in the S-Series stack.
Syntax
show system stack-ports [status | topology]
Parameters
Defaults
No default behavior
redundancy disable-auto-reboot Prevent the system from auto-rebooting if it fails.
status
(OPTIONAL) Enter the keyword status to display the command output without
the Connection field.
topology
(OPTIONAL) Enter the keyword topology to limit the table to just the Interface
and Connection fields.