Command Reference Guide

S-Series Stacking Commands | 1399

S-Series Stacking Commands

Overview

All commands in this chapter are specific to the S-Series s and platforms as

indicated by the characters that appear under each of the command headers.

The commands are always available and operational, whether or not the S-Series has a

stacking module inserted. You can use the commands to pre-configure a switch, so that the

configuration settings are invoked when the switch is attached to other S-Series units.

For details on using the S-Series stacking feature, the chapter “Stacking S-Series Switches”

in the

FTOS Configuration Guide.

Commands

The commands in this chapter are used for managing the stacking of S-Series systems:

• redundancy disable-auto-reboot

• redundancy force-failover stack-unit

• reset stack-unit

• show redundancy

• show system stack-ports

• stack-unit priority

• stack-unit provision

• stack-unit renumber

• stack-unit stack-group

• upgrade system stack-unit (S-Series stack member)

Caution: S4810 Stacking cannot be enabled simultaneously with VLT. If both are enabled at

the same time, unexpected behavior will occur.