Command Reference Guide

Simple Network Management Protocol and Syslog | 1391
logging history
c e s z
Specify which messages are logged to the history table of the switch and the SNMP network
management station (if configured).
Syntax
logging history
level
To return to the default values, enter no logging history.
Parameters
Defaults
4 or warnings
Command Modes
CONFIGURATION
Command
History
Usage
Information
When you configure the snmp-server trap-source command, the system messages logged to
the history table are also sent to the SNMP network management station.
Related
Commands
logging history size
c es z
Specify the number of messages stored in the FTOS logging history table.
Syntax
logging history size size
To return to the default values, enter no logging history size.
Parameters
Defaults
1 message
Command Modes
CONFIGURATION
level
Indicate a value from 0 to 7 or enter one of the following equivalent
words: emergencies, alerts, critical, errors, warnings, notifications,
informational, or debugging.
The default is 4.
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
show logging history Display information logged to the history buffer.
size
Indicate a value as the number of messages to be stored.
Range: 0 to 500.
Default: 1 message.