Command Reference Guide

1384 | Simple Network Management Protocol and Syslog
www.dell.com | support.dell.com
Syntax
snmp-server view
view-name oid-tree {included | excluded}
To remove an SNMPv3 view, use the
no snmp-server view view-name oid-tree {included |
excluded}} command.
Parameters
Defaults
No default behavior or values.
Command Modes
CONFIGURATION
Command
History
Usage
Information
The oid-tree variable is a full sub-tree starting from 1.3.6 and can not specify the name of a
sub-tree or a MIB. The following example configures a view named
rview that allows access
to all objects under 1.3.6.1:
Example
FTOS# conf
FTOS#(conf) snmp-server view rview 1.3.6.1 included
Related
Commands
snmp trap link-status
c e s z
Enable the interface to send SNMP link traps, which indicate whether the interface is up or
down.
Syntax
snmp trap link-status
To disable sending link trap messages, enter no snmp trap link-status.
Defaults
Enabled.
Command Modes
INTERFACE
view-name
Enter the name of the view (not to exceed 20 characters).
oid-tree
Enter the OID sub tree for the view (not to exceed 20 characters).
included
(OPTIONAL) Enter the keyword included to include the MIB
family in the view.
excluded
(OPTIONAL) Enter the keyword excluded to exclude the MIB
family in the view.
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
show running-config snmp Display the SNMP running configuration