Command Reference Guide

1376 | Simple Network Management Protocol and Syslog
www.dell.com | support.dell.com
Related
Commands
snmp-server group
c e s z
Configure a new SNMP group or a table that maps SNMP users to SNMP views.
Syntax
snmp-server group
[group_name {1 | 2c | 3 {auth | noauth | priv}}] [read name] [write name]
[
notify name] [access access-list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]]
To remove a specified group, use the
no snmp-server group [group_name {1 | 2c | 3 {auth |
noauth | priv}}] [read name] [write name] [notify name] [access access-list name | ipv6
access-list-name | access-list-name ipv6 access-list-name]] command.
Parameters
show snmp engineID
Display SNMP engine and all remote engines that are configured on
the router
show running-config snmp Display the SNMP running configuration
group_name
Enter a text string (up to 20 characters long) as the name of the
group.
Defaults: The following groups are created for mapping to read/write
community/security-names.
• v1v2creadg — maps to a community/security-name with ro
permissions
• 1v2cwriteg — maps to a community/security-name rw
permissions
1 | 2c | 3
(OPTIONAL) Enter the security model version number (1, 2c, or 3).
• 1 is the least secure version
• 3 is the most secure of the security modes.
• 2c allows transmission of informs and counter 64, which allows
for integers twice the width of what is normally allowed.
Default: 1
auth
(OPTIONAL) Enter the keyword auth to specify authentication of a
packet without encryption.
noauth
(OPTIONAL) Enter the keyword noauth to specify no
authentication of a packet.
priv
(OPTIONAL) Enter the keyword priv to specify both authentication
and then scrambling of the packet.
read name
(OPTIONAL) Enter the keyword read followed by a name (a string
of up to 20 characters long) as the read view name.
Default: GlobalView is set by default and is assumed to be every
object belonging to the Internet (1.3.6.1) OID space.
write name
(OPTIONAL) Enter the keyword write followed by a name (a string
of up to 20 characters long) as the write view name.
notify name
(OPTIONAL) Enter the keyword notify followed by a name (a string
of up to 20 characters long) as the notify view name.
Note: This parameter must be enabled on the receiver for traps to be
received.
access access-list name
(Optional) Enter the standard IPv4 access list name (a string up to 16
characters long).