Command Reference Guide

1372 | Simple Network Management Protocol and Syslog
www.dell.com | support.dell.com
To remove access to a community, use the no snmp-server community community-string {ro |
rw} [security-name name [access-list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]] command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Usage
Information
The example below configures a community named public that is mapped to the security
named
guestuser with Read Only (ro) permissions.
Example
FTOS#config
FTOS(conf)# snmp-server community public ro
FTOS(conf)# snmp-server community guest ro security-name guestuser
FTOS(conf)#
The security-name parameter maps the community string to an SNMPv3 user/security name
as defined by the community MIB.
If a community string is configured without a
security-name (for example, snmp-server
community public ro
), the community is mapped to a default security-name/group:
• v1v2creadu / v1v2creadg — maps to a community with
ro (read-only)
permissions
• v1v2cwriteu/ v1v2cwriteg — maps to a community with
rw
(read-write) permissions
This command is indexed by the
community-name parameter.
If the snmp-server community command is not configured, you cannot query SNMP data.
Only Standard IPv4 ACL and IPv6 ACL is supported in the optional
access-list-name.
community-name
Enter a text string (up to 20 characters long) to act as a password for
SNMP.
ro
Enter the keyword ro to specify read-only permission.
rw
Enter the keyword rw to specify read-write permission.
ipv6 access-list-name
(Optional) Enter the keyword ipv6 followed by a an IPv6 ACL
name (a string up to 16 characters long).
security-name name
(Optional) Enter the keyword security-name followed by the
security name as defined by the community MIB.
access-list-name
(Optional) Enter a standard IPv4 access list name (a string up to 16
characters long).
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.2.1.1 Introduced on E-Series