Command Reference Guide

sFlow | 1363
Parameters
Defaults
32768
Command Modes
CONFIGURATION
Command
History
Usage
Information
Sample-rate is the average number of packets skipped before the sample is taken. This
command changes the global default sampling rate. You can configure an interface to use a
different sampling rate than the global sampling rate. If the value entered is not a correct
power of 2, the command generates an error message with the previous and next power of 2
value. Select one of these two packet numbers and re-enter the command.
Related
Commands
sflow sample-rate (Interface)
c e s
Change the Interface default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, enter the no sflow sample-rate.
Parameters
Defaults
The Global default sampling
Command Modes
CONFIGURATION
value
Enter the sampling rate value.
Range: C-Series and S-Series: 256 to 8388608 packets
E-Series TeraScale and ExaScale: 2 to 8388608
Enter values in powers of 2 only; for example 4096, 8192, 16384, etc.
Default: 32768 packets
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
sflow sample-rate (Interface) Change the Interface sampling rate.
value
Enter the sampling rate value.
Range: C-Series and S-Series: 256 to 8388608 packets
E-Series TeraScale and ExaScale: 2 to 8388608 packets
Enter values in powers of 2 only, for example 4096, 8192, 16384 etc.
Default: 32768 packets