Command Reference Guide

sFlow | 1361
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS 7.8.1.0 and later enhances the sFlow implementation for real time traffic analysis on
the E-Series to provide extended gateway information in cases where the destination IP
addresses are learned by different routing protocols, and for cases where the destination is
reachable over ECMP.
Related
Commands
sflow polling-interval (Global)
c e s
Set the sFlow polling interval at a global level.
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
Defaults
20 seconds
Command Modes
CONFIGURATION
Command
History
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
sflow extended-gateway enable Enable packing information on an extended gateway.
sflow extended-router enable Enable packing information on a router.
show sflow Display the sFlow configuration
interval value
Enter the interval value in seconds.
Range: 15 to 86400 seconds
Default: 20 seconds
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series