Command Reference Guide

Routing Information Protocol (RIP) | 1243
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers
are possible.
Use the passive-interface command in conjunction with the neighbor command to ensure that
only specific interfaces are receiving and sending data.
Related
Commands
network
c e s
Enable RIP for a specified network. Use this command to enable RIP on all networks
connected to the switch.
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameter
Defaults
No RIP network is configured.
Command Modes
ROUTER RIP
Command
History
ip-address
Enter the IP address, in dotted decimal format, of a router with which to exchange
information.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
passive-interface Sets the interface to only listen to RIP broadcasts.
ip-address
Specify an IP network address in dotted decimal format. You cannot specify a
subnet.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series