Command Reference Guide

Routing Information Protocol (RIP) | 1239
Command Modes
ROUTER RIP
Command
History
Related
Commands
distribute-list out
c e s
Configure a filter for outgoing routing updates.
Syntax
distribute-list prefix-list-name out [interface | bgp | connected | isis | ospf | static]
To delete the filter, use the
no distribute-list prefix-list-name out command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list.
prefix-list-name Enter the name of a configured prefix list.
interface
(OPTIONAL) Identifies the interface type slot/port as one of the following:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed
by a number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to
4094.
connected
(OPTIONAL) Enter the keyword connected to filter only directly
connected routes.
isis
(OPTIONAL) Enter the keyword isis to filter only IS-IS routes.
Note: This option is only available on E-Series.
ospf
(OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static
(OPTIONAL) Enter the keyword static to filter manually configured routes.