Command Reference Guide

Quality of Service (QoS) | 1223
Queue-Level Debugging
Queue-Level Debugging is an E-Series-only feature, as indicated by the e character that
appears below each command heading.
The following queuing statistics are available on TeraScale versions of E-Series systems.
• clear queue statistics egress
• clear queue statistics ingress
• show queue statistics egress
• show queue statistics ingress
clear queue statistics egress
e
Clear egress queue statistics.
Syntax
clear queue statistics egress [unicast | multicast] [Interface]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If a Policy QoS is applied on an interface when clear queue statistics egress is issued, it will
clear the egress counters in show queue statistics and vice-versa. This behavior is due to the
values being read from the same hardware registers.
Related
Commands
unicast | multicast (OPTIONAL) Enter the keyword multicast to clear only Multicast queue
statistics. Enter the keyword unicast to clear only Unicast queue
statistics.
Default: Both Unicast and Multicast queue statistics are cleared.
Interface
(OPTIONAL) Enter one of the following interfaces to display the
interface specific queue statistics.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by the
slot/port information.
Note: Fast Ethernet is not supported.
Version 6.2.1.1 Introduced
clear queue statistics egress Clear ingress queue statistics