Command Reference Guide

1222 | Quality of Service (QoS)
www.dell.com | support.dell.com
Command
History
Usage
Information
Use this command to assign drop precedence to green or yellow traffic. If there is no honoring
enabled on the input, all the traffic defaults to green drop precedence.
Related
Commands
wred-profile
e
Create a WRED profile and name that profile.
Syntax
wred-profile wred-profile-name
To remove an existing WRED profile, use the
no wred-profile command.
Parameters
Defaults
The five pre-defined WRED profiles. When a new profile is configured, the minimum and
maximum threshold defaults to predefined wred_ge_g values
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use the default pre-defined profiles or configure your own profile. You can not delete the
pre-defined profiles or their default values. This command enables the WRED configuration
mode—(conf-wred).
Related
Commands
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Profile name character limit increased from 16 to 32.
pre-Version 6.1.1.1 Introduced on E-Series
wred-profile Create a WRED profile and name that profile
trust Define the dynamic classification to trust DSCP
wred-profile-name
Enter your WRED profile name in character format (16 character
maximum). Or use one of the pre-defined WRED profile names. You can
configure up to 26 WRED profiles plus the 5 pre-defined profiles, for a
total of 31 WRED profiles.
Pre-defined Profiles:
wred_drop, wred-ge_y, wred_ge_g, wred_teng_y, wred_teng_g
Version 8.3.7.0 Introduced on S4810
pre-Version 6.1.1.1 Introduced on E-Series
threshold Specify the minimum and maximum threshold values of the WRED profile