Command Reference Guide

PIM-Sparse Mode (PIM-SM) | 1115
Command Modes
INTERFACE
Command
History
ip pim register-filter
c e s
Use this feature to prevent a PIM source DR from sending register packets to an RP for the
specified multicast source and group.
Syntax
ip pim register-filter access-list
To return to the default, use the no ip pim register-filter access-list command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
The access name is an extended IP access list that denies PIM register packets to RP at the
source DR based on the multicast and group addresses. Do not enter this command before
creating the access-list.
ip pim rp-address
c e s
Configure a static PIM Rendezvous Point (RP) address for a group or access-list.
Syntax
ip pim rp-address
address {group-address group-address mask} override
To remove an RP address, use the no ip pim rp-address address {group-address group-address
mask} override command.
Parameters
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series on port-channels and S-Series
access-list
Enter the name of an extended access list. Maximum 16 characters.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced
address
Enter the RP address in dotted decimal format (A.B.C.D).