Command Reference Guide

1080 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
RouterID Flags Cost Nexthop Interface Area
3.3.3.3 -/-/-/ 2 10.0.0.2 Gi 0/1 1
1.1.1.1 E/-/-/ 0 0.0.0.0 - 0
FTOS#
You can determine if an ASBR is in a directly connected area (or not) by the flags. For
ASBRs in a directly connected area, E flags are set. In the figure above, router 1.1.1.1 is in a
directly connected area since the Flag is E/-/-/. For remote ASBRs, the E flag is clear (-/-/-/)
show ip ospf database
c e s
Display all LSA information. If OSPF is not enabled on the switch, no output is generated.
Syntax
show ip ospf process-id database [database-summary]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS>show ip ospf 1 database
OSPF Router with ID (11.1.2.1) (Process ID 1)
Router (Area 0.0.0.0)
Link ID ADV Router Age Seq# Checksum Link count
11.1.2.1 11.1.2.1 673 0x80000005 0x707e 2
13.1.1.1 13.1.1.1 676 0x80000097 0x1035 2
192.68.135.2 192.68.135.2 1419 0x80000294 0x9cbd 1
Network (Area 0.0.0.0)
Link ID ADV Router Age Seq# Checksum
10.2.3.2 13.1.1.1 676 0x80000003 0x6592
10.2.4.2 192.68.135.2 908 0x80000055 0x683e
Type-5 AS External
Link ID ADV Router Age Seq# Checksum Tag
0.0.0.0 192.68.135.2 908 0x80000052 0xeb83 100
1.1.1.1 192.68.135.2 908 0x8000002a 0xbd27 0
10.1.1.0 11.1.2.1 718 0x80000002 0x9012 0
10.1.2.0 11.1.2.1 718 0x80000002 0x851c 0
10.2.2.0 11.1.2.1 718 0x80000002 0x7927 0
10.2.3.0 11.1.2.1 718 0x80000002 0x6e31 0
10.2.4.0 13.1.1.1 1184 0x80000068 0x45db 0
process-id Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF
process.
database-summary
(OPTIONAL) Enter the keywords database-summary to the display
the number of LSA types in each area and the total number of LSAs.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series