Command Reference Guide

Open Shortest Path First (OSPFv2) | 1079
Related
Commands
show ip ospf asbr
c e s
Display all ASBR routers visible to OSPF.
Syntax
show ip ospf process-id asbr
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
Use this command to isolate problems with external routes. In OSPF, external routes are
calculated by adding the LSA cost to the cost of reaching the ASBR router. If an external
route does not have the correct cost, use this command to determine if the path to the
originating router is correct. The display output is not sorted in any order.
Example
FTOS#show ip ospf 1asbr
“SPF schedule...” Displays the delay and hold time configured for this process ID.
“Convergence Level”
“Min LSA....” Displays the intervals set for LSA transmission and acceptance.
“Number of...” Displays the number and type of areas configured for this process
ID.
Table 37-2. Command Output Descriptions: show ip ospf process-id
Line Beginning with Description
show ip ospf database Displays information about the OSPF routes configured.
show ip ospf interface Displays the OSPF interfaces configured.
show ip ospf neighbor Displays the OSPF neighbors configured.
show ip ospf virtual-links Displays the OSPF virtual links configured.
process-id Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.8.1.0 Introduced process-id option, in support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and E-Series
Note: ASBRs that are not in directly connected areas are also displayed.