Command Reference Guide

Open Shortest Path First (OSPFv2) | 1069
Command Modes
INTERFACE
Command
History
Usage
Information
Set the time interval to a number large enough to prevent unnecessary retransmissions. For
example, the interval should be larger for interfaces connected to virtual links.
ip ospf transmit-delay
c e s
Set the estimated time elapsed to send a link state update packet on the interface.
Syntax
ip ospf transmit-delay seconds
To return to the default value, enter no ip ospf transmit-delay.
Parameters
Defaults
1 second
Command Modes
INTERFACE
Command
History
log-adjacency-changes
c e s
Set FTOS to send a Syslog message about changes in the OSPF adjacency state.
Syntax
log-adjacency-changes
To disable the Syslog messages, enter
no log-adjacency-changes.
Defaults
Disabled.
Command Mode
ROUTER OSPF
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
seconds
Enter the number of seconds as the transmission time. This value should be
greater than the transmission and propagation delays for the interface.
Range: 1 to 3600.
Default: 1 second.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series