Command Reference Guide

1014 | Multicast
www.dell.com | support.dell.com
Related
Commands
debug ipv6 mld_host
Enable the collection of debug information for MLD host transactions.
Syntax
[no] debug ipv6 mld_host [int-count | interface type] [slot/port-range]
Use the no debug ipv6 mld_host command to discontinue collection of debug information for
the MLD host transactions.
Parameters
Default
Disabled
Command Modes
EXEC
Command
History
Usage
Information
Use the debug ipv6 mld_host command to debug the MLD protocol for all ports or for
specified ports. Displayed information includes when a query is received, when a report is
sent, when a mcast joins or leaves a group, and some reasons why a MLD query is rejected.
ipv6 multicast-limit
e
Limit the number of multicast entries on the system.
Syntax
ipv6 multicast-limit limit
Parameters
Defaults
15000 routes
show ipv6 pim tib Display the IPv6 PIM Tree Information Base.
int-count Enter the keyword count to indicate the number of required debug messages.
interface type Enter the following keywords and slot/port information:
• For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet
followed by the slot/port information.
• For a 10G Ethernet interface, enter the keyword tengigabitethernet
followed by the slot/port information.
• For a 40G interface, enter the keyword fortyGigE followed by the slot/port
information.
• For a management interface enter the keyword managementinterface
followed by the slot/port information.
• For a port-channel interface, enter the keyword port-channel followed by
the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by the slot/port
information.
Version 8.3.12.0 Introduced on the S4810.
limit
Enter the desired maximum number of multicast entries on the system.
Range: 1 to 50000
Default: 15000