Command Line Reference Guide

any Enter the keyword any to specify that all routes are subject
to the filter. You can enter any of the following keywords to
specify route types.
• bytes — Enter the keyword count to count packets the
filter processes.
• count — Enter the keyword bytesorder to count bytes
the filter processes.
• dscp — Enter the keyword dcsp followed by the DCSP
value to match to the IP DCSCP values. The range is from
0 to 63.
• fragments — Enter the keyword fragments to use
ACLs to control packet fragments.
• order — Enter the keyword order to specify the QoS
order of priority for the ACL entry. The range is from 0 to
254 (0 is the highest priority and 254 is the lowest; lower-
order numbers have a higher priority). The default is, if
you do not use the keyword order, the ACLs have the
lowest order by default (255).
host ip-address Enter the keyword host and then enter the IP address to
specify a host IP address only.
Defaults Not configured.
Command
Modes
CONFIGURATION-STANDARD-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Add the DSCP value for ACL matching.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added support for the non-contiguous mask and added the
monitor option.
Version 6.5.1.0 Expanded to include the optional QoS order priority for the
ACL entry.
Access Control Lists (ACL)
213