Command Line Reference Guide

Command
Modes
CONF-CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VRF ID .
Related
Commands
class-map — identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
S4810
Syntax
match mac access-group {mac-acl-name}
Parameters
mac-acl-name Enter a MAC ACL name. Its contents is used as the match
criteria in the class map.
Defaults none
Command
Modes
CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Available on the C-Series and S-Series.
Version 7.5.1.0 Added support for the DSCP Marking option.
1344
Quality of Service (QoS)