Specifications

Installing the S25P System 31
Installing SFPs
To install an SFP transceiver into an open optical port at the right front of the switch, use the follow steps:
Note: Starting with FTOS 7.8.1.0, when a copper SFP2 module with catalog number GP-SFP2-1T is used
in the S25P switch, the SFP speed can be manually set with the
speed command. When the speed is set to
10 or 100 Mbps, the
duplex command can also be executed.
Warning: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear
an ESD-preventive wrist or heel ground strap when handling the S25P and its components.
Step Task
1
Position the SFP so it is in the upright position. (The SFP has a key that prevents it from being inserted
incorrectly.)
2 Insert the SFP into the port until it gently snaps into place.
Figure 19 Front View of S25P with SFP
fn00161s25P
S25-01-GE-24P